1. Forum
  2. FidoNet
  3. FIDOTEST

  • Testing my config...

    From Alan Ianson@1:153/757.2 to malkonix on Wed Jan 20 19:39:52 2021
    Re: Testing my config...
    By: malkonix to All on Wed Jan 20 2021 11:25 pm

    i am receiving the netmail and only need to recieve by fidonet

    You'll need to adjust your AKA setup for this area.

    Your message appears to originate from 1:0/0 or 0:0/0

    Ttyl :-),
    Al

    ... It's hard to be serious when you're naked.
    --- SBBSecho 3.12-Linux
    * Origin: The Rusty MailBox - Penticton, BC Canada (1:153/757.2)
  • From Flavio Bessa@4:801/188 to malkonix on Thu Jan 21 08:46:14 2021
    On 21/01/21 00:25, malkonix -> All wrote:
    i am receiving the netmail and only need to recieve by fidonet
    --- SBBSecho 3.11-Linux
     * Origin:  (0:0/0)

    Got your message here. However, as you can see, your origin line is missing, as
    well as your node address.

    --
    Flavio Bessa - 4:801/188 - Rio de Janeiro, Brasil
    fcbessa@gmail.com

    --- Thunderbird/MacOS 78.6.0
    * Origin: Andromeda - Saturn's Orbit NNTP Gateway (4:801/188)
  • From Alan Ianson@1:153/757.2 to malkonix on Thu Jan 21 15:14:40 2021
    Re: Testing my config...
    By: malkonix to Alan Ianson on Thu Jan 21 2021 09:14 am

    i am in the process of learning to use and operate an BBS but now i think at least now is configured the Origin line

    Your messages look good and do travel the network without issue but the origin address is missing.

    You can set that for each message area in the network options settings of the message areas. Look in there for fidonet address and set your address.

    thanks for the help

    No worries and I hope that helps.

    Ttyl :-),
    Al

    ... Cursor: An expert in four-letter words
    --- SBBSecho 3.12-Linux
    * Origin: The Rusty MailBox - Penticton, BC Canada (1:153/757.2)